Spring Gauges

OVee's spring gauges allow the easy and precise measurement of internal and external threads, taps, and gauge control with use of calibrated gauges. We can supply gauges to suit your own exact requirements, including male/female up to 10" in diameter, single/multi start, or pre-plate.

Brencor Gauges ©

We supply a selected range of Brencor's gauges, including their Chamfer-Chek which can measure both the top, and the minor diameter of tapered holes, chamfers, or conical parts. Their Hole-Chek allows instant measurement of the diameter of small holes. Both are availible in digital or analogue models.

Other Products and Services

OVee are proud to be able to supply a full range of hard to find engineering equipment including : screw thread gauges, HSS Taps, Dies and  Dienuts, Coventry Chasers, End Mills and Slot Drills, Tangential Chasers, Thread, Knurl & Spline Rolls, Tap & Die Sets, and Ratchet Pipe Threaders.

ABOUT US

The O-Vee Thread Spring Gauge


A Simple but Effective method of Screw Thread Measurement and Gauging.

Widely used by industry both at home and abroad who recognise its virtues both as a measuring tool for external and internal thread forms (except the square form) and as an In House Plug Gauge Calibration System.

The Ovee permits the setting and controlling of batch runs with such ease and less trial scrap and when used in conjunction with the solid ring gauge extends the life of these units by reducing the bell mouthing and wear which occurs through the constant trials necessary to ensure the component enters the gauge with little or no drag.

Speciality form measurement has not limited the Ovee to measuring screw threads alone but includes undercuts and slots, grooves etc.

Any combination of Diameter, Pitch, Lead (starts) from .9mm to 356mm diameter can be produced within days and at truly economical prices as well as the standard forms and sizes currently used with Unified, I.S.O. Metric, Whitworth, Buttress, Acme, to name but a few.

The Gauge Control Ovee is solely for the In-House Calibration of Thread Plug Gauges and because the G-C Ovee has all the over-wire dimensions including wear parameters for both Go and No Go members where specifications permit on its data plate. The calibration can be under taken by any level of staff member providing they are able to use and read a micrometer.

Remember that with the Ovee Gauge all calculations and specifications have already been taken care of, the user need only fit the gauge upon or into the component or gauge to be measured and apply the measuring tool (micrometer/vernier/plategauge etc) and ensure the measured results are within the nominated figures specified on the Ovee gauge data plate.

The OVEE is SIMPLE EFFECTIVE ECONOMIC.

Try one; You have little to loose but so much to gain:

For our catalogue which covers all the products we supply the Industry and the Individual Engineer/Model Maker.